Hex file generated from e2studio not running if i download using Renesas flash programmer

 Hi,

 

I am working on RX62N Series . I am using R5F562N8BDFB microcontroller. I generated hex file using e2studio and downloaded using Renesas flash programmer.

After downloading from RFP , program not running in microcontroller.

But if i compile using HEW then it is working.

 

Please help me to understand the issue .

 

 

Regards,

Savindra Kumar

  • Are you sure you use the same options in e2 studio and in HEW?
    Have you tried to program the hex file generated by HEW?
  • In reply to FrankL:

    Are you sure you use the same options in e2 studio and in HEW?

    I have checked the compiler and linker settings in e2studio , which are same .
    when i run the code in debug mode in e2studio , it is working fine.
    But if i use hex file generated by e2studio and flash using RFP , it is not working.
    Renesas RX Toolchian Version in e2studio - v02.06.00
    Do i need to generate hex file in release?

    Have you tried to program the hex file generated by HEW?
    Yes it is working .
    Renesas RX Toolchian Version in HEW- v1.2.1.0
  • In reply to SAVI:

    This thread will be archived due to inactivity.

    Mike Clements
    RenesasRulz Moderator