How to fix data at 00ceH to consistent with _start?

 With debugger T32, in debugging R5F10BGGL, _start address is 21B3, but reset vet data at 00ceH is 2019.

Then debugging will error if reset for the wrong reset address at 00CEH.

I want to know how to fix data at 00ECH?

  • The reset vector is located at address 0x0000 (se table 3-3 in hardware user's manual).
    Address 0x00CE is the start of the user program area.
    I have no idea if trace32 requires that the reset vector is also written to 0x00CE. If so I would assume trace32 should write this itself.
  • lucky,
    Have you found the answer you were looking for?

    Mike Clements
    RenesasRulz Moderator
  • This thread will be archived due to inactivity.

    Mike Clements
    RenesasRulz Moderator