port xip-linux on rza1lu board

Application: Port xip-linux on renesas rz board.
 
+ Platform : Renesas RZA1LU
+ Host OS : Linux
+ Referred Web for porting XIP linux : https://elinux.org/RZ-A/Boards/Stream-it
 
we need support for below error,
 
we are trying to boot our board through serial console. while booting, system stuck at booting linux, after this step system is not responding.
As per our knowledge because  of memory linux is not booting properly.
please give support for same, or correct me if i am making mistake in booting steps.
Thank you,
regards
Krishna
 
 
 
 
krishna@krishna-T430:~$ minicom -s

Welcome to minicom 2.7

OPTIONS: I18n
Compiled on Nov 15 2018, 20:18:47.
Port /dev/ttyACM0, 16:23:04

Press CTRL-A Z for help on special keys



U-Boot 2017.05-gfa1edce (Jul 23 2019 - 20:45:25 +0530)

CPU: Renesas Electronics CPU rev 0.0
Board: STREAMIT
I2C: ready
DRAM: 3 MiB
SF: Detected mx25l51235f with page size 256 Bytes, erase size 64 KiB, total 64 B
In: serial_sh
Out: serial_sh
Err: serial_sh
SPI Flash Memory Map
------------------------------------
Start Size SPI
u-boot: 0x00000000 0x080000 0
env: 0x00080000 0x040000 0
DT: 0x000C0000 0x040000 0
Kernel: 0x00200000 0x600000 0
rootfs: 0x00800000 0x1C00000 0
Net: Please set MAC address
sh_eth
Error: sh_eth address not set.
 
=>run xsa_boot
SF: Detected mx25l51235f with page size 256 Bytes, erase size 64 KiB, total 64 B
device 0 offset 0xc0000, size 0x8000
SF: 32768 bytes @ 0xc0000 Read: OK
Current Mode: Read Mode (3-byte Addr) (RZ/A1 reset value)
SF: Detected mx25l51235f with page size 256 Bytes, erase size 64 KiB, total 64 B
New Mode: Quad I/O Read Mode (4-byte Addr)
Booting Linux...