RH850/F1KM-S4 deep stop mode current

Hello,

I would like to know if i can get some typical data about RH850/F1KM-S4 current requirement while in deep stop mode , ambient temperature say 25 degC or max 40 degC. I only want the MCU to wake up to active mode -when it receive an interrupt on a pin. The datasheet specifies a range over temperature for Deep Stop Mode current requirement.Is there any typical test data available to make an architecture design decision?

Also please let me know if i configure instead of one single pin interrupt say an additional two separate interrupt pins for wake up, will the the current draw will be more?

Thank you for the support,

Regards,

Stephen Thomas