I am using e2studio v7.1.0 for my RX63N programming. I am using the FIT modules for various functions.
So far when I generate the code, it lands directly in the PROJECT Folder. I have been ok with it.
Now I would like the code to land in a specific folder inside the project. Is there a possibility to configure this??
Using the project variables perhaps??
Thanks in advance!!
Have you already found the answer to this? Maybe chapter 7 of this manual https://www.renesas.com/eu/en/doc/products/mpumcu/apn/rx/002/r01an1685ej0380-rx.pdf will help.
JBRenesasRulz Forum Moderator
In reply to JB:
In reply to Kaushik: