Good afternoon, tell me how through ez-cube, upload to microcontroller 78F0527DA firmware (.hex) ?
In reply to ivan224415:
Okay, V2.05 is available.
In reply to Kirin:
I know that pin p31 it should be = 0.
And there must be a source, external interrupts.(generator)
The following materials which you showed are for on-chip debugging.
And below the figure shows flash serial programming circuit.
The terminal treatment of P31 seems to be appropriate. pulldown is okay.
I know !
The 14pin?16pin? connector is MINICUBE2 with 78K0-OCD board.
Hi Ivan, Could you close this thread, if your question is complete? :-)