Good afternoon, tell me how through ez-cube, upload to microcontroller 78F0527DA firmware (.hex) ?
Hi Ivan, Uploading the memory is possible by starting the debugger(CS+ CA,CX). tool-support.renesas.com/.../db_kinou_prog_download9.html
In reply to Kirin:
The rest is how to connect me ?
In reply to ivan224415:
Wiring is described in Chapter 5.1.2 (page.44) of EZ-CUBE Users manual.
How should these pins be installed?
Can you use debbuger(CS+ CA,CX) ?
1st. picture Select "78K0 EZ Emulator" on "(DebugTool)" , then select "Main clock source" of "Clock" "Generate by emulator" and 8.00[MHz] on Propaty of "(Debug Tool)".
2nd. picture select "Connect to Debug Tool" from menu bar "Debug"
3rd. picture select "Uploading Memory Contents" from menu bar "Debug"
The debugger can be got below.
[Evaluation Software] CS+ for CA,CX V4.01.00 (Single Download)
Did you download it ?
Okay, it's not need update. Proceed ahead to skip it. As CA,CX Version 4.01 is old software, I think that there is probably no update anymore.