Error Using E1 to read/write V850E2/Fx4-L

I have test results between RFP2.05 and RFP3.06 as same RL 78 hardware
1. RFP v3.06 with E1 emulator good results
2. RFP v2.05 with E1 emulator bad results
3. RFP v3.06 with simple circuit type B good results
4. RFP v2.05 with simple circuit type B good results
Why E1 emulator doesn't work with RFP v2.05 ?
I think the problem of V850E2/Fx4-L is the same. But RFP v3.06 is not supported.
Please advise me.

Hi ae,

Have you checked this thread if the response from Scott helps you: http://renesasrulz.com/other_products/v850/f/v850---forum/10440/using-e1-to-read-write-mcu-flash

JB
RenesasRulz Forum Moderator

https://renesasrulz.com/
https://academy.renesas.com/
https://en-us.knowledgebase.renesas.com/

If target frequency incorrect settings will affect or not be ? My target board use 6.0 MHz oscillator. RFP 2.05 can't settings. how to settings. please advise me

Hi ae,

Sorry, I don't have this device so I can't even try this. Scott's response on that thread that I've linked talks about if there's a circuit in your target board which makes the device unable to be read or programmed. Are there other components attached on the pins that you've used for reading or programming? If not, maybe the issue is with the clock settings also that you're suspecting. Please check the hardware manual too.

JB
RenesasRulz Forum Moderator

https://renesasrulz.com/
https://academy.renesas.com/
https://en-us.knowledgebase.renesas.com/

Hi ae,

Sorry, I don't have this device so I can't even try this. Scott's response on that thread that I've linked talks about if there's a circuit in your target board which makes the device unable to be read or programmed. Are there other components attached on the pins that you've used for reading or programming? If not, maybe the issue is with the clock settings also that you're suspecting. Please check the hardware manual too.

JB
RenesasRulz Forum Moderator

https://renesasrulz.com/
https://academy.renesas.com/
https://en-us.knowledgebase.renesas.com/

I have tried using gray zone hacking tools it can connect with 6 MHz frequency settings . I have a problem with checksum Therefore would like to try using RFP v2.05. The RFP can set 16MHz minimum .How to I set 6 MHz?