1. I am working on Lychee Mbed board. I have selected "Renesas GDB Hardware Debugging" option in configuration, with "target Type: R7S721030". But I am getting an error with Jlink.
2. Can you give me Step by Step process to debug using jlink? (I have connected the cable correctly, no issues in this. Once I was able to debug using JLINK, but after that only Power LED is good, I am getting the error. )
3. I have imported the "lychee_Sketch" of Mbed Platform. Also It takes a lot of time to compile when I build it?
4. Only LED 5 is glowing with green color. LED 4 is glowing which is red in color. Also, Jlink LED goes Red when I start Debug.
Any updates on this issue? Were you able to solve this already?
JBRenesasRulz Forum Moderator
Hi, sorry for delay reply.
The below is my debug configuration. Do you select "J-Link ARM" ? Which project version did you import, v1.02 or v1.03 ? When I exported v1.03, I had not connected to J-Link, so it doesn't have debug setting. So you may set debug setting.