About the camera mounted on the Kaede board

Hello all,

I was viewing the details about the Kaede board and I found that the kaede board with the camera mounted has all the ports covered by the shield as per the image.

Will the camera shield have to be removed to access the other pins or will there be extensions present on the shield

GR-KAEDE with option

If the application requires both the camera and the other ports what must be done?

Even though the question is a bit early this came up in our group discussion.

  • Hi,

    Thanks for posting this. I had the same question as well :)

  • In reply to Yuvaraj:

    I am too looking for the answer. Having the same question.

    After carefully observing the camera shield, most of the pins are not used by camera. But there are empty holes left on the board for the camera unused pins. May be we should insert our own pin hooks. Whatever may be, lets wait and listen from the experts.

  • In reply to Suresh Babu:

    Yes you should be able to mount bergs strips and use GPIOs which are not used by camera and sd card.

    Regards,

    Shrenik