While downloading code to target board r5f104ffa I am getting following error.
[Direct Error Cause]Can not communicate with Emulator. Please terminate the debugger and check the power of Emulator or the connection of cable then restart the debugger.(E1200265)
But the same emulator works fine with r5f104pja demo board.
I am using cubesuite+ IDE and E1 Emulator.
I am not getting that is this issue is with board /cubesuite+ /Emulator.
Please help me with solving this issue.
Thanks and regards,
In reply to FrankL:
In reply to Megha:
In reply to Mike Clodfelter:
This is schematic which I am having now.
1. PIN2(TOOL0) of MCU is connected to PIN1 of PGM and PIN1 of PGM is also connected to PIN5 of E1 emulator which is not shown in this schematic.
2. PIN3(RESET) of MCU is connected to PIN2 of PGM and PIN2 of PGM is also connected to PIN10 and PIN13 of E1 emulator which is not shown in this schematic.
3. PIN3 of PGM is connected to the PIN8(VDD) of E1 Emulator.
Thanks and Regards
From your explanation you do not have a RESET input signal connected to pin 6 of E1.
Target GND has to be connected to pins 2, 12 and 14 of E1.
You don't connect EVDD (pin 9).
Below I attached two circuit connection diagrams for program our board with E1 Emulator.
Please help in choosing correct circuit diagram so that I can program my renesas IC.
In reply to Mike Clements: